If you get dairy goats, you’ll probably want to build this nifty stanchion to make milking easy for both the milker and the milkee. The stanchion features an adjustable seat for the milker, a platform to raise the goat to a comfortable height and a feed box to keep her content while you milk.
To build a goat milking stanchion, you’ll need a skill saw, jigsaw, electric drill, Phillips screwdriver for the drill, a 1/16-inch drill bit to bore pilot holes for screws and 1 1/2-inch wood screws.
If you want, you can add a chain neck restraint, which will come in handy when introducing a new goat to milking.
The Milking Stanchion
Materials
FRONT: Begin with the two 44-inch 1x12s (A). Lay one on top of the other. Using a jigsaw cut out one half of the keyhole. Start the bottom of the keyhole at 19 inches with the top ending at 39 inches. (See illustration in the image gallery for the shape, which may need to be enlarged to accommodate a goat with horns.) Lay the two boards (A) side by side and screw the top connector (H) flush with the top. Use four 11/2-inch screws. Mount the L-brackets (I) flush with the bottom of front (A) on each outside edge, again using the 11/2-inch screws.
FLOOR: Position the two bottom boards (B) side by side. As pictured, position the slide supports (F) under the bottom boards (B) and screw down from the top using 12 1½-inch screws, six per support. Attach the seat slide (D) across the bottom and flush with the outside edge of the slide support (F).
BRACING: Screw the leg supports (C) to the slide supports (F) using six 1 1/2-inch screws in each. Attach the legs (E) to the leg supports (C) and to the bottom (B) on all four corners. Attach each leg using four 1 1/2-inch screws, two in the top and two in the side.
TO ATTACH FRONT TO FLOOR: Attach the front (A) to the bottom (B) using the L-brackets (I) previously installed on the front (A). Position brace (G) as shown in the diagram and screw to the front (A) and the bottom (B) flush with the far side of the stanchion.
If you’d like a restraint to confine your goat loosely to the stanchion, attach screw eye (K) to the right side near the bottom of the keyhole. Attach chain (J) to the screw eye (K). Attach the screw hook on the left side of the keyhole so you can fasten the chain loosely.
The Goat Milking Seat
Materials
Mark and cut the two sides (B) as indicated on the diagram. Attach adjustable slide (A) onto sides (B) 8 1/2 inches from the bottom. Use three 1 1/2-inch screws on each side. Attach the top (C) across the top of the sidepieces allowing 2 inches of overhang on each. Attach with six 1½-inch screws, three on each side.
The Goat Milking Feed Box
Materials
Screw the front and back (A) to the sides (B). Use two 1 1/2-inch screws in each corner. Attach bottom (C) using three 1 1/2-inch screws per side. Attach L-brackets to the bottom of the box, flush with outside edge. These will later attach the feed box to the stanchion.
